View Single Post
Old 02-24-2017, 07:59 AM
Mel's Avatar
Mel Mel is offline
Join Date: Mar 2005
Location: Dallas area
Posts: 10,160

Originally Posted by Roy25101 View Post
Could I get some advice on how to go about cutting the excess metal off the R-710 Rudder Brace Horn. It won't go through a band saw, it's too thick to snip. Any advice would be appreciated.
Typically on situations like this, I use a cut-off wheel in a Dremel or die grinder. Wear eye protection and be careful.
Mel Asberry..DAR since last century
A&P/EAA Tech Counselor/Flight Advisor/Nat'l Test Pilot School
Specializing in Amateur-Built and Light-Sport Aircraft
North Texas (8TA5)
RV-6 Flying since 1993, 172hp O-320, 3-Blade Catto (since 2003)
Legend Cub purchased 12/2017
FRIEND of the RV-1
Eagle's Nest Mentor
Recipient of Wright Brothers "Master Pilot" Award
Reply With Quote