tomhanaway
Well Known Member
So close to the end and this happens. Had wings on stands and was bringing inside due to projected high winds. Spar end slipped off rack and dropped about 6 inches onto ground.
Two pictures attached.
Do I need to rebuild the whole tank section?
Alternatively, I could round out (reform metal at tip for the space from the rib to the edge) and fill the remaining (other side of rib) with Rage or equivalent.
Dent is about 2.5" long and 1/2 inch deep.
**** it.
Thanks for any help and advice.
Tom Hanaway
Boynton Beach, FL
Two pictures attached.
Do I need to rebuild the whole tank section?
Alternatively, I could round out (reform metal at tip for the space from the rib to the edge) and fill the remaining (other side of rib) with Rage or equivalent.
Dent is about 2.5" long and 1/2 inch deep.
**** it.
Thanks for any help and advice.
Tom Hanaway
Boynton Beach, FL