View Single Post
  #5  
Old 11-12-2017, 08:03 AM
bret's Avatar
bret bret is online now
 
Join Date: Feb 2010
Location: Gardnerville Nv.
Posts: 2,781
Default

ya these were fun, this is where I drilled my first finger hole....after doing the true up on the bench and installing tape and marking witness marks on the tape and cut the green tape open, I placed on gear leg to see where the hinge would go and have the trailing edge tight, marked the hinge location, went and riveted one side of the hinge then back on the plane and lined up witness marks and drilled other side of hinge on the gear leg.
__________________
7A Slider, EFII Angle 360, CS, SJ.
2018 gladly supported
Reply With Quote