All,
I saw the answer to this in a thread that I can no longer find. I have some erratic-ness in my oil pressure gauge and bought a manual gauge from HF to do some testing.
My oil pressure sending unit is mounted inside the firewall under the panel, I originally thought of unscrewing it and putting the manual gauge there for ground testing but then I don't get to compare the two so we'll scratch that bad idea.
Is there a preferred location on the accessory case or block that I should be using? I see a plug very close to the pressure relief valve that looks like a good candidate but thought I'd ask the collective before I do something I'll regret later.
Thx!
Tim
I saw the answer to this in a thread that I can no longer find. I have some erratic-ness in my oil pressure gauge and bought a manual gauge from HF to do some testing.
My oil pressure sending unit is mounted inside the firewall under the panel, I originally thought of unscrewing it and putting the manual gauge there for ground testing but then I don't get to compare the two so we'll scratch that bad idea.
Is there a preferred location on the accessory case or block that I should be using? I see a plug very close to the pressure relief valve that looks like a good candidate but thought I'd ask the collective before I do something I'll regret later.
Thx!
Tim