Hi Guys,
I'm just trimming the baffles on an angle valve engine and at the top of cylinder number 2 I have about 1/8 of an inch left on the baffle and its just about clearing the cowl (maybe a 1/16).What have other guys done in this situation,is it possible to file down the top of the cylinder above the screw a little bit as there is plenty of meat on it there?
Open to suggestions,
Cheers
I'm just trimming the baffles on an angle valve engine and at the top of cylinder number 2 I have about 1/8 of an inch left on the baffle and its just about clearing the cowl (maybe a 1/16).What have other guys done in this situation,is it possible to file down the top of the cylinder above the screw a little bit as there is plenty of meat on it there?
Open to suggestions,
Cheers