SteFree RV-8
Member
Hello Group...
I have been working on the Horizontal Stabilizer and I am at the point where it is time to skin it. I have the pre-punched kit and it seem like a jig is not necessary but I wanted to reach out to you guys to see if you can offer advice for the best way to do this. If I need to build a jig I will but I can't find anything in the plans for this and in looking on the internet I can't find anything there. I have the GeoBeck videos but the techniques he discusses seem outdated to the modern kits.
Can anyone offer advice or best practices? I have read the manual and I know I can proceed but I am sure those of you who have, "been there and done that" can offer tricks.
Does anyone have any pictures from their builds they can share?
Any help or guidance is greatly appreciated.
Thanks in advance
Steve (reserving N902SE) Freeman
I have been working on the Horizontal Stabilizer and I am at the point where it is time to skin it. I have the pre-punched kit and it seem like a jig is not necessary but I wanted to reach out to you guys to see if you can offer advice for the best way to do this. If I need to build a jig I will but I can't find anything in the plans for this and in looking on the internet I can't find anything there. I have the GeoBeck videos but the techniques he discusses seem outdated to the modern kits.
Can anyone offer advice or best practices? I have read the manual and I know I can proceed but I am sure those of you who have, "been there and done that" can offer tricks.
Does anyone have any pictures from their builds they can share?
Any help or guidance is greatly appreciated.
Thanks in advance
Steve (reserving N902SE) Freeman