Thread: Edge Distance
View Single Post
Old 03-29-2017, 05:01 PM
mturnerb mturnerb is offline
Join Date: Apr 2015
Location: Ponte Vedra, FL
Posts: 835

Originally Posted by asw20c View Post
Yeah, not helpful. Even if you follow the directions, when you match drill the elevator horns, depending on how the tolerances stack up, you could possibly be drilling too close to the edge, unless you know what the minimum is.
The instructions have you use the aft most horn (marking distances to keep good edge margins) for the first hole so that the matching hole goes into the other horn with good edge distance. If your horns are off so much that you're flirting with edge distance on the forward one you may want to call Van's for advice.
Turner Billingsley
RV-14A In Progress
N14VB Reserved
Reply With Quote