Stockmanreef
Well Known Member
So it looks like I have plenty of toe in with the axle alignment. Left side is 2.7 mm (1.5 degrees) and the right is 4.5 mm (2.5 degrees). Assuming I did the measurement correctly. That is $150 to shim the axles, since I will need 5 shims. Another hidden cost. Should Van's be responsible for this cost? Another hidden cost. Plus, after reading another thread about this issue, does the washer need to be shimmed as well. And will the bolt slide through when canted out 2.5 degrees?
what are people typically getting?
I talked to Vans and they said 2.5 degrees is the upper end of the angle.
Thanks
Ken
what are people typically getting?
I talked to Vans and they said 2.5 degrees is the upper end of the angle.
Thanks
Ken