I see in the Beringer sheet for the main wheels to use on each side 3 AN4-21A and 1 AN4-16.
The following close tolerance bolts are same size:
AN4-16 -> AN6604-21
AN4-21 -> AN6604-27
The drawing from Vans shows AN1304-29, which should be a little longer than both of these. AN6604 superseded AN1304 so they are the same thing.
So if you have installed this... Did your install have the Vans bolts too long or too short? Anyone get these close tolerance bolts?
The following close tolerance bolts are same size:
AN4-16 -> AN6604-21
AN4-21 -> AN6604-27
The drawing from Vans shows AN1304-29, which should be a little longer than both of these. AN6604 superseded AN1304 so they are the same thing.
So if you have installed this... Did your install have the Vans bolts too long or too short? Anyone get these close tolerance bolts?