Home made bar
Originally Posted by airguy
Any piece of steel that you can get wedged in there with sufficient mass to buck against will work. I sacrificed a couple tools to make custom bucking bars for some of the more difficult spots, including a 3/8" wrench and a large screwdriver in one case. All it has to do is be heavy and be in the right spot.
What he said. If you need more mass, tape a tungsten bar to it.
Estes Park, CO
wirejock at yahoo dot com
Donated 12/27/2018. Plus a little extra.
RV-7A #73391, N511RV reserved (2,000+ hours)
HS SB, empennage, tanks, wings, fuse, working finishing kit
I cannot be, nor will I be, held responsible if you try to do the same things I do and it does not work and/or causes you loss, injury, or even death in the process.