View Single Post
  #9  
Old 11-29-2017, 11:52 AM
Bill Boyd's Avatar
Bill Boyd Bill Boyd is offline
 
Join Date: Sep 2006
Location: Landing field "12VA"
Posts: 1,180
Default

Quote:
Originally Posted by vernon smith View Post
I would think so as well, a 100 degree drill point is two 50 degree angles one on either cutting face, a 120 degree is two 60 degree cutting faces so the contact point with the 100 degree dimple would be on it's outer edge unless there is something about all this I don't understand. Seeing I was recently chastised on the forum as a naive newbie, I may be way off base
Vern, we can at least go off to a corner and hallucinate together

So if we're right, why does the paint not want to lay right on these pulled rivets in 100 degree dimples? Or is that not a thing, either??
__________________
Bill Boyd

Hop-Along Aerodrome (12VA)
RV-6A - N30YD - flying since '98
RV-10 - N130YD reserved - under construction

donating monthly to the VAF - thanks, Doug
Reply With Quote