View Single Post
Old 09-21-2017, 04:12 PM
tomkk's Avatar
tomkk tomkk is offline
Join Date: Apr 2014
Location: Port Orange, Fl
Posts: 798

Originally Posted by DonFromTX View Post
I sent my Sensenich two blade prop back to Sensenich for upgrade to the new hub and settings. Essentially you are furnished a set of pins which you stick in a hole of the new hub, then rotate the blade until the newly installed pins installed by Sensenich contacts.
I cannot find anyone in the archives that has done this, and I was wondering how well this new method gets the blades equal with each other, and which pin others have found to result in the most favorable pitch.
Stretching my recollection a bit but I seem to remember starting with a number 3 pin. That only got me in the ballpark and I used a digital level and Van's fixture to fine tune it and get the blades pitched exactly the same.
Port Orange, Fl
RV-12 N121TK ELSA #120845; first flight 06/10/2015
RV-12 N918EN ELSA #120995 Eagles Nest Project
SPA Panther N26TK in progress
Reply With Quote