View Single Post
  #12  
Old 11-30-2017, 09:12 PM
nedricher nedricher is offline
 
Join Date: Jan 2013
Location: Peoria, AZ
Posts: 76
Default

Toward the end of your post you say you got no drop in rpm with a mag check, then later on a normal check? I would disconect the p leads and run it. That would eliminate the switch and associated wiring. You wont be able to check the mags individually, but it might just solve the problem. Just be carefull because the mags will be hot all the while the p leads are off.
Reply With Quote