I'm back to the re-assembly on the wing, mounted the leading edge and now when I went to attach the tank back on, I can't get it lined up. The top side sits too far farward so I can't get the screw holes to line up. Of course, it all fit at one point before I prosealed.
I possibly could force it down with some straps but if I do that, will I ever be able to get it back on when I'm doing the final final assembly when I'm done?
The z-brackets are bolted down and the bottom side lines up okay.
I also have a few spots where the tank skin won't sit flush with the leading edge and it won't seat into the countersink holes. I thought it may have been some proseal not allowing it to sit flush with the splice, but I don't see any excess.
Any suggestions?
The top side screw holes not lining up...
The skin sitting high and won't go flush...
I possibly could force it down with some straps but if I do that, will I ever be able to get it back on when I'm doing the final final assembly when I'm done?
The z-brackets are bolted down and the bottom side lines up okay.
I also have a few spots where the tank skin won't sit flush with the leading edge and it won't seat into the countersink holes. I thought it may have been some proseal not allowing it to sit flush with the splice, but I don't see any excess.
Any suggestions?
The top side screw holes not lining up...
The skin sitting high and won't go flush...