View Single Post
  #6  
Old 04-02-2018, 12:50 PM
rv7charlie rv7charlie is offline
 
Join Date: May 2006
Location: Pocahontas MS
Posts: 3,158
Default

Quote:
Originally Posted by bkervaski View Post
Yep, I tried the short bits too.



These rods are steel .. but I don't mind tearing a couple bits up if I can get them drilled properly.
I've used mine on steel quite a few times without noticeable issues. Don't expect them to last like hi-$ stuff, but you're not going to use something like this for production work.
Reply With Quote