Hey guys,
I finally got back on my -7 build and it has been going fairly well. That was, until I began riveting the wing ribs to the main spar. I ended up with approx 20 rivets that should be replaced. I used a 10 degree offset rivet set on my 3x gun with the little red plastic cover installed. I work alone, which is probably part of the problem. I completed one wing and am about to start on the other. Any suggestions?
I finally got back on my -7 build and it has been going fairly well. That was, until I began riveting the wing ribs to the main spar. I ended up with approx 20 rivets that should be replaced. I used a 10 degree offset rivet set on my 3x gun with the little red plastic cover installed. I work alone, which is probably part of the problem. I completed one wing and am about to start on the other. Any suggestions?