Thread: Fuse Floor Pans
View Single Post
  #1  
Old 02-12-2018, 03:08 PM
rvanstory's Avatar
rvanstory rvanstory is offline
 
Join Date: Dec 2016
Location: New Braunfels
Posts: 138
Default Fuse Floor Pans

In process of putting in front floor pans on RV10. All is going well EXCEPT, the holes that are to be riveted to the lower fuse channels are WAY off! Match drilling all went well, but now, they aren't even close. I can't force it over enough to even get close.

Has anyone else experienced this? Any suggestions?

https://lh3.googleusercontent.com/22...U=w587-h780-no

__________________
Randy Vanstory
Building RV10
N783V - Reserved
Flying Mooney M20J
Emp Kit Completed, Section 29 done, Tail Cone Attached, QB Wings delivered and stored for now.
Dues Happily Paid 2018
Reply With Quote