View Single Post
Old 08-12-2017, 08:43 PM
leok leok is offline
Join Date: Apr 2013
Location: Clarkston, MI
Posts: 228

Originally Posted by Tommycat View Post
Hi leok,

Contactor/relay coil diodes required? (voltage spike drain.)

Diodes are installed. Wow, you guys are good at picking out details!! I will add them the the drawings

Termination location of the annunciator sensor wire at the starter contactor. (12VDC +)

VPX provides that with a wire from the starter relay direct to connector-pin, J2-11. Again I will add to the drawing.

Resistor in the annunciator sensor wire circuit? (Near the starter contactor.)

1 K ohm resistor is installed

Best regards,

Once again, I appreciate the comments and questions.
Building my RV-10 since Oct 5th 2014
Flying .. once I figure out how to pay for everything
RV Hotel
Dues paid 2018
Reply With Quote