Well I am finally at the point of mounting my horizontal stab on my VERY slow build 6A. After wrestling with the stab for a while I decided to check the rear spar mounting bars. One, the blurry image, is the good side. The square is flat against it and the other leg falls right on the center line (picture 1). The other side is offset towards the back of the plane 0.125 on the outside and one sixteenth on the inside. Has anyone else run into this and what was the fix? Thanks in advance.
Here's the good one:
This is the problem!
I hope the pictures show up now. I see them when I look at the page.
Any help appreciated!
Paul
Here's the good one:
This is the problem!
I hope the pictures show up now. I see them when I look at the page.
Any help appreciated!
Paul
Last edited: