David Paule
Well Known Member
I've got my airplane hardware in parts bins with little clear plastic drawers. To label the drawers, I'm using a white on clear tape. This lets me see past the labels into the drawer, and because the printing is white, it's easy to see when the bins are up against the wall and there's not a lot of light.
The label tape is for any labeler that uses 1/2" TZ tapes. Its TZe-135.
My Brother labeler lets me adjust the spacing between labels and print out a string of them without cutting them. That saves tape. When I've got a convenient batch printed, the labeler can cut the tape, and then I'll snip them off, one by one.
Dave
The label tape is for any labeler that uses 1/2" TZ tapes. Its TZe-135.
My Brother labeler lets me adjust the spacing between labels and print out a string of them without cutting them. That saves tape. When I've got a convenient batch printed, the labeler can cut the tape, and then I'll snip them off, one by one.
Dave