N73JE
Member
I'm getting my tools assembled and was looking over the tool list on Van's website.
I see the usual 3/32" Rivet Dimple Die and 1/8" Rivet Dimple Die. I also see #8 Screw Dimple Die. And in the forums I have read that a #10 Screw Dimple Die will be required as well.
Is there something different about a "screw" vs "rivet" die? Are the screw heads not at 100 degrees or something?
I was looking at buying the dies at "The Yard":
http://www.yardstore.com/browse.cfm/2,405.html
They are all 100 degree "spring back" dies and seem well priced.
Also, are 3/16" Rivet Dimple Dies the same as #10 Screw Dimple Dies?
Inputs?
Thanks!
I see the usual 3/32" Rivet Dimple Die and 1/8" Rivet Dimple Die. I also see #8 Screw Dimple Die. And in the forums I have read that a #10 Screw Dimple Die will be required as well.
Is there something different about a "screw" vs "rivet" die? Are the screw heads not at 100 degrees or something?
I was looking at buying the dies at "The Yard":
http://www.yardstore.com/browse.cfm/2,405.html
They are all 100 degree "spring back" dies and seem well priced.
Also, are 3/16" Rivet Dimple Dies the same as #10 Screw Dimple Dies?
Inputs?
Thanks!
Last edited: