proppershope
Member
I have my stabilizer completed and I have found a mistake. I trimmed the HS-301 skins even with HS-303 spars. I didn't notice the overhang of the skins until I was fitting up the right elevator. It isn't shown on the main stabilizer drawing and I missed it.
So how do I fix? Can I add a gap seal strip of say .016 on the top and bottom of the stabilizer? Any suggestions other than replacing the skin would be helpful.
Andy
So how do I fix? Can I add a gap seal strip of say .016 on the top and bottom of the stabilizer? Any suggestions other than replacing the skin would be helpful.
Andy