Hi,
The directions for the roll bar say to drill a hole and then tap it for a 8-32 screw. I couldn't find anything that says what size hole to drill. Do you just measure the width of the tap minus the threads, or is there an actual specified drill size for a 8-32 hole?
Thanks
Vince
RV-7 QB builder. Tip up
The directions for the roll bar say to drill a hole and then tap it for a 8-32 screw. I couldn't find anything that says what size hole to drill. Do you just measure the width of the tap minus the threads, or is there an actual specified drill size for a 8-32 hole?
Thanks
Vince
RV-7 QB builder. Tip up