While match drilling the aft undrilled hole on a center stiffener I elongated it in one direction significantly. I re-drilled it up to #33 for use with a 7/64 (half-size) oops rivet. Two questions:
1) because this is the last hole on the stiffener and not supported by a standard 3/32 rivet is use of an oops rivet suitable or should I drill it up to 1/8 for a -4 rivet even through this will not be aesthetically the best option?
2) If I use a -4 rivet will the shop heads of the two stiffeners touch since this is right at the bend in the trailing edge?
Thanks
See photos on my site:
https://eaabuilderslog.org/?blprojentry&proj=7YL1dRvO9&e=7YQrss2xx&listcat=
1) because this is the last hole on the stiffener and not supported by a standard 3/32 rivet is use of an oops rivet suitable or should I drill it up to 1/8 for a -4 rivet even through this will not be aesthetically the best option?
2) If I use a -4 rivet will the shop heads of the two stiffeners touch since this is right at the bend in the trailing edge?
Thanks
See photos on my site:
https://eaabuilderslog.org/?blprojentry&proj=7YL1dRvO9&e=7YQrss2xx&listcat=