I am looking for guidance / best methods to install a dual landing light in my "completed" LEFT wing (RV12is). A few questions:
1) Does the wire need to be threaded through the existing snap bushings? That task appears difficult. Not sure if the wire can be routed through the ribs and remain loose.
2) Are there any "tricks" to install the landing light ribs / light?
3) Are there additional wires needed for the "right" wing to ensure you get the wig wag effect?
Any suggestions / help is appreciated.
Thanks
1) Does the wire need to be threaded through the existing snap bushings? That task appears difficult. Not sure if the wire can be routed through the ribs and remain loose.
2) Are there any "tricks" to install the landing light ribs / light?
3) Are there additional wires needed for the "right" wing to ensure you get the wig wag effect?
Any suggestions / help is appreciated.
Thanks