This is directed to Stein, or anyone else that can give me some insight.
After powering up my system this past weekend, everything appears to be working with the exception of my stabilator trim. I'm getting power back there to the servo, but very little. Question .... is the full range of the potentiometer trim about 3/4 of a turn? That's all I can get. In one extreme direction, pressing the trim control switch it makes no noise and no movement. In the other extreme direction the motor makes some noise and is trying to move the trim, but is able to move the shaft maybe 1/8 - 1/4 inch if I hold it long enough. There is no resistance since the trim tabs are off and the pushrod is just laying on something.
Any suggestion in where I go from here.
JT
After powering up my system this past weekend, everything appears to be working with the exception of my stabilator trim. I'm getting power back there to the servo, but very little. Question .... is the full range of the potentiometer trim about 3/4 of a turn? That's all I can get. In one extreme direction, pressing the trim control switch it makes no noise and no movement. In the other extreme direction the motor makes some noise and is trying to move the trim, but is able to move the shaft maybe 1/8 - 1/4 inch if I hold it long enough. There is no resistance since the trim tabs are off and the pushrod is just laying on something.
Any suggestion in where I go from here.
JT