I am at a point the I need to crawl into the aft fuse to do a variety of misc tasks (including some of the upper skin riveting). Currently the fuse is 'right side up' & supported on the spar and at the tail. So a couple questions:
1- In the configuration, can the fuse support the weight of a 180lb person?
2- Recommendations on what to put in the bottom of the fuse (distributing between the skins and frames)
If needed, I can also support at the aft baggage compartment frame (with obviously significantly less load if that's not need, I'd prefer not to.
Thanks
1- In the configuration, can the fuse support the weight of a 180lb person?
2- Recommendations on what to put in the bottom of the fuse (distributing between the skins and frames)
If needed, I can also support at the aft baggage compartment frame (with obviously significantly less load if that's not need, I'd prefer not to.
Thanks