Hi all,
I?m going to close the vertical stabilizer riveting the skin.
At the same time I placed a conduit inside and now I need to create a hole in the upper rib vs1006 front position.
I read a lot about and I saw several solutions. Honestly I?d like to place also a couple of nutplate to attach future camera.
The question is I?d like to have some document explaining the possibility to adopt these modifications.
In other words, what I need is to validate the modificarion.
Also, I?m sure that during the technical inspection I will have to demonstrate that the hole can not create any issue.
So, are there anybody with some official documents from Vans reporting such kind of informations? or are there any other data could be used for that?
Thanks a lot
Francesco
I?m going to close the vertical stabilizer riveting the skin.
At the same time I placed a conduit inside and now I need to create a hole in the upper rib vs1006 front position.
I read a lot about and I saw several solutions. Honestly I?d like to place also a couple of nutplate to attach future camera.
The question is I?d like to have some document explaining the possibility to adopt these modifications.
In other words, what I need is to validate the modificarion.
Also, I?m sure that during the technical inspection I will have to demonstrate that the hole can not create any issue.
So, are there anybody with some official documents from Vans reporting such kind of informations? or are there any other data could be used for that?
Thanks a lot
Francesco