Stockmanreef
Well Known Member
I read the "gotcha" read up on this and suffice it to say that it is impossible to install after the fact, since drilling that hole is impossible and I have other things that I would rather do, than install the flap cranks.
The question is: Can you drill the hole in a different location on the flap crank. Higher up the flap crank so it can be drilled without removing the flap crank? It looks like the travel of the sensor is about 1".
I guess the really question is: Why is drilling that hole not part of the plans? I assume that this sensor is something that pre-existed the rv-14 and has been installed in the rv-10.
The question is: Can you drill the hole in a different location on the flap crank. Higher up the flap crank so it can be drilled without removing the flap crank? It looks like the travel of the sensor is about 1".
I guess the really question is: Why is drilling that hole not part of the plans? I assume that this sensor is something that pre-existed the rv-14 and has been installed in the rv-10.