Mikeandmaz
Active Member
I?ve seen from another builders blog that forming the Rudder leading Edge lap joint bend is quite difficult if done as per the plans. So I thought I?d do the bend before I start riveting it all together. In Section 5.10 it states the bend should be about 1/4 inch in. This would put the bend through the holes on this occasion, so would I be right in assuming the bend needs to be closer to the edge in this case?
Apologies for such a mundane question, I?ll try for a better one next time.
Mike
Apologies for such a mundane question, I?ll try for a better one next time.
Mike