BGordon
Well Known Member
Good morning everyone,
I am hoping to have my engine mount (tail draggin 7) attached to my firewall within the next few days and was wondering. I have seen build websites in which part of the firewall was cut out/grinded down to allow clearance for the landing gear, but I can?t seem to find any measurements. Does anyone know where these are, and if they aren?t published, what would be an acceptable clearance...1/8, 1/4??
Thanks in advance,
Brandon
I am hoping to have my engine mount (tail draggin 7) attached to my firewall within the next few days and was wondering. I have seen build websites in which part of the firewall was cut out/grinded down to allow clearance for the landing gear, but I can?t seem to find any measurements. Does anyone know where these are, and if they aren?t published, what would be an acceptable clearance...1/8, 1/4??
Thanks in advance,
Brandon