I ordered my RV-14 empennage kit so now it's time to start asking really, really basic questions. On the very first page of the build instructions, it says to "dimple the rivet holes on the aft face of the VS-702 Front Spar and VS-01401 Front Spar Doubler" and then in the associated Figure 4 it says "dimple flush aft." Does this mean to dimple toward the aft or dimple toward the front so the flush side is to the aft? I assume the latter, but I don't want to act on a bad assumption on the very first page of the kit.
I look forward to getting started on the build. Rest assured that I will have more basic questions as I go, and for posterity I will make future builders even more comfortable asking their basic questions since they can't possibly be more basic than mine.
I look forward to getting started on the build. Rest assured that I will have more basic questions as I go, and for posterity I will make future builders even more comfortable asking their basic questions since they can't possibly be more basic than mine.