When overlapping the inboard and outboard skins and clecoeing in preparation for riveting, there?s a small gap between the two skins that I?m not happy with. The first time I noticed this, I thought I?d been too aggressive with my deburring and emailed the mothership with some pictures to get help. They said the gap wasn?t a flight safety issue so it was my decision to order new skins or build on. I decided to order new skins. They just arrived. I clecoed the new skins in place before doing any deburring, and guess what? There?s a small gap at the trailing edge where the two skins overlap. My conclusion is that it?s either normal to be there or else the factory punched holes are off very slightly. Can someone else who?s built their wings tell me if there?s a tiny gap between the two skins where they overlap? Now I?m disappointed that I may have needlessly paid for new skins. The gap is less than 1/16? but noticeable. Thanks