N329JR
Active Member
I believe that I have seen a post or two on this issue previously.
I have riveted the the upper skins on recently and see that the skins trailing edge at the rear spar is turned up some amount.
I am wondering if all builders are running into this issue and are dealing with it by making a slotted bending block and bending the skin/rear spar flange combination back down flush.
Thanks for any input.
Ian
I have riveted the the upper skins on recently and see that the skins trailing edge at the rear spar is turned up some amount.
I am wondering if all builders are running into this issue and are dealing with it by making a slotted bending block and bending the skin/rear spar flange combination back down flush.
Thanks for any input.
Ian