Mine are just right. Easy enough for my toddler to open, but sticky enough that they don't blow open on their own. I do have the handle extensions on them as part of the Aerosport interior panel set.
Anybody have, maybe, a 3D print solution for the RV10 rear side vents? I'm thinking maybe something like what Aerosport has but without the whole panel.
It?s something to figure out. I didn?t tighten the nur enough at speeds 170 kt + . It?s hard to tighten if you have the aerosportproducts console.
Mike
They do provide air while taxiing, but it's not the same as in flight (obviously). In AZ I would be using my ice-chest air conditioner a whole lot more.
Our son lives in Surprise, and it get too darn hot there during the summer months.
As said “it’s a feel thing as far as tightness goes, trial and error” a little Armorall on the nylon washers make them slide nice as well. I’ve found they are Easy to push out but a little harder to close, drill a hole and install a good quality key ring for pull closing. They work well when taxying on the ground, and I like to make use of them combined with open front vents to provide air circulation when the aircraft is parked.