Lynnb
Well Known Member
So I've searched and read a lot on fitting the mcmaster door seals. Several people reference using a piece of seal to form the correct edge profile, but I can't find any exact detail. So my question(s) are:
1. Do you slide the door seal on and then inject it with epoxy/cabosil mix and then slide it out of the way to form the proper door frame thickness?
2. Do you put a release agent/tape on the inside of the mcmaster seal channel, inject it with epoxy/cabosil mix, let it set-up and then remove it?
3. Some other magic?
Thanks in advance,
Lynn
1. Do you slide the door seal on and then inject it with epoxy/cabosil mix and then slide it out of the way to form the proper door frame thickness?
2. Do you put a release agent/tape on the inside of the mcmaster seal channel, inject it with epoxy/cabosil mix, let it set-up and then remove it?
3. Some other magic?
Thanks in advance,
Lynn