VAF Forums

VAF Forums (http://www.vansairforce.com/community/index.php)
-   RV-10 (http://www.vansairforce.com/community/forumdisplay.php?f=4)
-   -   A Tip for QB builders (http://www.vansairforce.com/community/showthread.php?t=163985)

lr172 09-08-2018 01:51 PM

A Tip for QB builders
 
My QB fuse was shipped in 07. Today I took out the wood spacers installed in the main spar cavity (between the two sides) and found some light corrosion on the anodized portion and a lot of corrosion on the un-anodized part.

It all cleaned off without any pitting or problems. However, I recommend that builders pull the wood out early in the process. I suspect the wood absorbs moisture and holds it in tight contact with the parts.

Larry


All times are GMT -6. The time now is 03:28 PM.