rjcthree
Well Known Member
Preflighting today found my ailerons locked in place. All power to the A/C was off. Troubleshooting led to finding the AP roll servo mechanically locked. Disconnecting the servo arm from the aileron belcrank resumed normal operation of the ailerons. Servo itself remained locked until power was turned on. At that point the servo seemed to act normally, no error codes. I removed the servo. Since removing the servo, I can?t replicate the mechanical locking. It?s going back to Dynon.
Has anyone else experienced mechanical locking of a servo without power? I should note that the AP was used on the previous flight to this one, and functioned normally.
Has anyone else experienced mechanical locking of a servo without power? I should note that the AP was used on the previous flight to this one, and functioned normally.