Bernie RV7
Member
I have seriously bad inside tire wear on both sides of my recently purchased RV6..
Lots of toe out... also suspect bent legs as the left wing tip is about 3'' lower than the right. There is no firewall or fuselage distortion or damage to the engine mount.
Is there any way of knowing if the legs were factory drilled or drilled by the builder?....
What are my options of rectification .... thanks Bernie
Lots of toe out... also suspect bent legs as the left wing tip is about 3'' lower than the right. There is no firewall or fuselage distortion or damage to the engine mount.
Is there any way of knowing if the legs were factory drilled or drilled by the builder?....
What are my options of rectification .... thanks Bernie