I mocked up some foam to simulate seat height on my RV-9A.
In sitting left seat I noticed the control stick was biased toward the right. Very little room to roll right but lots of room on the left.
This spacing is controlled by the factory holes in the 904 bulkhead web and the weldment fits perfectly. So this seems like a bit of tubular weldment (maybe about an 1") is missing to center it.
The holes for the crotch straps, rudder pedals and seat are all centered, it's just the left stick's base weldment.
I know someone with an RV-7 who noticed the same as he is at about the same place in his build. Anyone gone to VANS to replace the weldment?
Thanks.
In sitting left seat I noticed the control stick was biased toward the right. Very little room to roll right but lots of room on the left.
This spacing is controlled by the factory holes in the 904 bulkhead web and the weldment fits perfectly. So this seems like a bit of tubular weldment (maybe about an 1") is missing to center it.
The holes for the crotch straps, rudder pedals and seat are all centered, it's just the left stick's base weldment.
I know someone with an RV-7 who noticed the same as he is at about the same place in his build. Anyone gone to VANS to replace the weldment?
Thanks.