VAF Forums

VAF Forums (http://www.vansairforce.com/community/index.php)
-   RV-14 (http://www.vansairforce.com/community/forumdisplay.php?f=109)
-   -   Flap position pushrod... (http://www.vansairforce.com/community/showthread.php?t=168353)

kbalch 01-31-2019 01:42 PM

Flap position pushrod...
 
I have my flap actuation system (torque arms and flap crank) ready to install and am working on my flap position pushrod.

Looking at pages 54-02 and 54-04, I'm having a difficult time visualizing the plane of the 45-degree lower bend. I just about have myself convinced that it's exactly the same as the upper 90-degree bend, but figured I'd check first.

If that's the case, is the pushrod sufficiently secure at its lower end? Doesn't seem like much holding it in there...

kbalch 02-01-2019 07:42 AM

Just to close the loop on this:

I was correct in that the plane of the 45-degree bend is the same as the 90-degree's. I couldn't believe that it's as simple as that, but it is.

Onward!


All times are GMT -6. The time now is 07:22 AM.