Hi guys
I've got a JPI 700 on my RV-4 and yesterday after replacing the alternator I did a run-up to check everything out and to my surprise I didn't have any indications initially on number# 3..
After a few minutes, I started getting a very low reading on the CHT but nothing on EGT and the JPI was telling me about the spread between the remaining cylinders.I shut down and wiggle the probes connections and recheck with the engine off and I had a temp reading on # 3...
I re-started the engine and again no indications...
Anyone ever had this problems and have any idea what could be the cause??
Thank you for your imputs
Bruno
[email protected]
I've got a JPI 700 on my RV-4 and yesterday after replacing the alternator I did a run-up to check everything out and to my surprise I didn't have any indications initially on number# 3..
After a few minutes, I started getting a very low reading on the CHT but nothing on EGT and the JPI was telling me about the spread between the remaining cylinders.I shut down and wiggle the probes connections and recheck with the engine off and I had a temp reading on # 3...
I re-started the engine and again no indications...
Anyone ever had this problems and have any idea what could be the cause??
Thank you for your imputs
Bruno
[email protected]