MurphysRV6A
I'm New Here
Hi everyone,
Has anyone else had any problems with the pushrod bumping the bottom of the F-641 in the full forward position?I have checked and double checked both the pushrod installation and the mounts for the control column and am unable to get it any lower. I spoke with vans a while back about it and they said to just cut a notch in the center of the F-641 at its lowest spot so it doesnt hit the pushrod. Also this notch will be between the side panels for the electric flap actuator.
Any ideas folks? I am at a loss....
Erik
RV-6A
Has anyone else had any problems with the pushrod bumping the bottom of the F-641 in the full forward position?I have checked and double checked both the pushrod installation and the mounts for the control column and am unable to get it any lower. I spoke with vans a while back about it and they said to just cut a notch in the center of the F-641 at its lowest spot so it doesnt hit the pushrod. Also this notch will be between the side panels for the electric flap actuator.
Any ideas folks? I am at a loss....
Erik
RV-6A
