- WhooHoo! I like this format so much more!
- Introductions
- Oil cooler fittings
- Larger tires?
- RV-4 w/ Retractable gear?
- rockets...
- Ditching
- Fuel smell
- RV Classified Board
- Starting Canopy
- TO flap setting question
- Introduction
- fuselage pics....
- RV4 exhaust 0320 E2D Dyno. Mount
- RV-4 Gear Leg
- F-402c
- 230hp rv-4
- I need a formation photo
- Aft canopy skirt closure
- endurance
- canopy restraint
- Manual flap handle
- Fuselage pics and help....
- Sliding Canopy anyone?
- Sam James cowling
- Canopy taxi stop?
- Houston Area RV A & P???
- Battery location?
- Vents for GIB
- RV-4 Progress Shots
- Question for you 'Travellin' Men'
- Vortex Generators
- Show us a pic of your RV-4 !!!
- Show us the status of your RV-4 project!
- New engine for RV-4!
- Correct Tire Pressure
- Manual aileron trim
- Mini-filter / Oil Filter
- Leading edge tape- opinions, please.
- RV-4 air vents
- Taxi Position Latch
- Canopy weatherstrip
- Front canopy fairing attach
- Canopy Handle Question
- -4 Pre Punched
- FAB help!!!
- 200 Hp
- RV-4 Canopy
- Capacatance senders
- RV-4 info for purching
- Jig timber
- Building the RV-4
- RV-6 tanks
- Prop Guard repair?
- Wheel Pants Fairing
- Installing Wings
- RV-4 CG issues?
- Remote Mount Oil Filter?
- Fuse Block Location
- Instrument Panel Design
- Wanted RV4
- Flap Hinge
- RV4 Roll Bar
- RV-4 verses RV-8 ????
- Fuel Selector Vavle Too Tight!!
- Extra glass on edges of cowling
- What is It....
- Rv-4 Hs And Vs
- auxiliary baaggage compartment
- vents
- Propellers
- catto propellers
- Antenna Location
- RV-4 Rear Rudder Pedals with Brakes
- RV-4 Mods From Rob Ray
- Installing Engine
- elevators etc....
- Bus Location
- RV-4 Instrument Panel Oversize
- RV-4 engine mount gussets
- RV-4 Aerobatics
- Leading edge ribs.
- Aluminum Wing Root Fairing
- Installing Cowl
- What to use to seal out air coming in front of canopy?
- engine 125 hp
- Escort Duty
- RV4 Weldment update
- RV Insurance
- rv4 cockpit,interior...
- rv-4 weldments
- Prop Balancing
- Final Weldment update
- Final Final weldment update
- Electric to Manual Pitch Trim?
- Instrumentation....
- RV-4 Gear Leg Fairings
- Anybody been to the Bahamas lately?
- Landing Gear Conversion
- Roll Axis Autopilot
- solid state instrumentation
- Climbing Technique
- Canopy with no holes in plexiglass
- RV-4 Master Cylinder Orientation
- More flap handle questions
- Upper Flap Skin Trimming/Bending?
- Cheek Cowls
- Tail Wagging
- wanted: flying RV-4
- aft-most wing/fuse intersection fairing
- Painting
- Used Lycoming Engines
- Landing Gear Support required?
- Front seat bottom-layer "cushion"
- Gascolator Installation
- Rob 'Smokey' Ray: Bandit
- Change of W&B?
- Huge Photo of Doug Weiler's RV-4 cockpit layout
- Starting from scratch
- Alternator noise filters
- Carb Vs Ellison TBI?
- Wiring Electric Aileron Trim
- Condition inspection squawks
- need!!!!!!!
- Firewall Forward with 4 into 1 Exhaust?
- Rudder cable exit hole?
- Dummy vs. Lycoming oil systems
- Heading down hill...
- For RV Buyers, not builders..
- Smaller pressure senders
- Cabin Heat
- Cowl fit
- Building leading edge
- Help building my RV-4
- Rear seat belt bracket for 5th point - RV4
- Elevator Travel Question
- RV-4 firewall buckle and cracks
- Re: small wing tip landing lights (HID)
- rear rudder pedal parts numbers
- Nightmare Annual
- match drilled spar carry-though?
- RV-4 Shops?
- No throttle, no check ride--
- Rear Controls (again)
- tail skins
- Rob Ray's SnF Roundup
- RV-4 Fastback Question
- What should I be aware of while buying RV4?
- Floscan
- Cowl Fabrication
- Fuselage Progress
- heater
- canopy taxi position lock??
- To fair or not to fair..
- May Sport Aerobatcs
- Exit air fairing - lower firewall.
- Dual Lightspeed Ignition project
- RV-4 with sliding canopy!
- RV-4 landing gear
- PIX: Custom Fastback Canopy Fairing
- Gear legs and engine mount
- Untouched New 1988 RV4 Kit
- Rigging flaps & ailerons
- Room for pilot? (a.k.a. Will I fit?)
- Progress...Canopy Install, etc.
- Rear Rudder Cable Clamp??
- Help with fuel selector valve!
- Canopy Side Skins....Problems
- Bending the stick
- Prop Quandry: Installation of 3-blade??
- Rollbar support sstructure - help please!
- Free: RV-4 fuselage jig (NorCAL), you pick-up in Red Bluff
- RV-4 ride
- Show us your panel!
- Lycoming/FAA Chain letters-- (Rant)
- Alternate induction intake
- Oxygen in your -4?
- Bonding to acrylic
- Rudder trim
- Stock cowl cheek extensions
- Flap Drive Installation
- F-428 step and storage.
- Fastback Conversion
- Arlington....
- Project status.
- Control Column, Stick and F-449 bracket
- Avgas storage question
- Lycoming O 320H2A(D)
- RV-4 oil dipstick 320
- plastic brakeline
- foreward bagage compartment
- New Noise
- Throttle prop and mixture quadrant position?
- RV-4 flap connection lost!
- foreward canopy skin
- Flap handle weldment
- F-440 push rod
- dual controls
- What would I do differently on my RV-4
- need dimension on RV4????
- canopy cover question.....
- Metal brake lines
- rear-seat max
- Jigging and Drilling Requirements
- Cowl fit
- Auxiliary Baggage
- Elevator Trim wiring
- Adding an air filter on an rv4
- Garmin antenna on top of roll bar.
- Battery location for O-360 CS -4
- RV-4 PIREP: Cam Benton (part I)
- RV-4 PIREP: Cam Benton (part II)
- Throttle quadrant
- RV-4 Riveted Trailing Edges
- Potential Flaps Gotcha
- Static port location
- Pitot location
- RV-4 Pilots
- Rebuilding elevators
- Drilling canopy and Filler for canopy
- RV-4 LSA
- rv4 engine heat shield
- RV-4 Cockpit size
- RV-4 QB?
- Smokey....Help!
- Drilling?
- runway length
- Fastback Conversion for RV-4?
- F-443
- Rear Seat F-443 / F407
- RV4 Safety canopy latch
- Questions on RV4 vs. RV8
- Tire Air
- Hit a brick wall: Prop bolts. I need help on this.
- AUTOPILOT/DIGITRAK SERVO INSTALL PICS?
- Canopy Install and other stuff
- interior
- Securing brake lines
- elevator trim
- What wood prop should I get?
- Engine frame from VANS - dimensional accuracy?
- What is a RV4 worth
- Water Spots
- Winter ops -- reducing inlet area
- Vacuum Cover Plate
- RV-4 panel
- Cowl / fuselage interface - help please?
- static port
- Engine Install Pictures
- Empennage skin overlap