- New Forum
- RV-8 List
- Coldest flight?
- Grove gear
- Tailwheel tightness
- Need RV-8 Builder
- Fuselage Jigging Problems
- Wing Attachment & Rigging
- Finished wing dimensions
- Fwd Baggage Door
- Canopy skirt
- fuel pump
- Fwd Baggage Door
- Engine Mount
- Superior Engine
- ELT Antenna
- to dimple or countersink F-817 plate
- Lightening holes
- Flymore seats
- Little Nervous!
- Paint Schemes
- When to put in on the gear
- Question for a friend
- Brake master cylinders
- Cowl/Baffle Transition
- Sheared
- VS hinge brackets
- Rudder cable fairing(Long one)
- Another grove gear?
- QB regrets...
- rudder cable conflict with step mount
- RV8A gear weldment installation problems
- RV 8 throttle on RHS ?
- Pic of main gear weldment shim on RV8A needed
- Kit-Panels.com
- RV-8 Finish Kit
- Fiberglass Tips
- RV8 Canopy Sealing
- Where can I find RV-8 Limitations?
- RV 8 Grove AF Gear
- RV 8A Electric Flap Motor
- new rudder pedal mods for 8/8A
- Decision RV7A versus RV8A
- floor platenuts
- ground adjustable rudder pedals
- Removable Floor Panels
- Canopy question
- Jacking an RV8
- Position/Landing Lights
- Portable GPS in Panel
- Show us a pic of your FINISHED RV-8/8A!!!
- Show us the status of your 8/8A project!
- Where to start with a QB fuse?
- Where to mount belly antennas (comm)
- Remote oil filter mounting
- Rudder Position and Strobe installation
- Flop tube in QB tank
- Air Inlet Housing
- Canopy Skirt Lessons Learned
- RV-8 QB gear installation
- Ground adjustable rudders
- Engine / prop combo for the -8
- Canopy Shade
- Glassing over rivets on Canopy Skirt
- Parachute choices
- Upper Gear Leg Intersection Fairings for -8A
- Wing root fairing gap seal
- Extra Fuel Tank 80 Gallons For Rv7
- Visitng St Louis
- Cowl to firewall attachment
- Flap hinge length
- Trimming RV-8 Canopy
- EGT Placement
- V- speeds?
- RV-8/-8a Builders' Meeting
- on the LIT - Central ramp??
- Fiberglass Lessons Learned
- Exhaust System Mounting Kit
- First Flight, Farthest North (?) RV-8A
- Halleluja!!
- Install Cowling
- Need a clue to glue
- RV-8 Elevator Trim Cable
- Arlington Award winners 2005-sorry large size
- Fitting a Andair FS20X3 fuel selector
- Stab incidence
- Does anybody recognize these?
- Canopy Noise - suggestions please
- Wheel Pant Alignment
- Flap riveting question
- Wingtips
- Final Assembly Hardware
- RV8 on floats
- Timing for wing construction
- Battery installation in forward baggage
- Elevator fiberglass tip options
- NACA vent inlet on -8 cowl?
- Fuel Tank Dimpling
- Heat / Cool Air mixer / selector box
- Value/Sale Price
- How well does the RV-8 fly?
- Intersection fairings for RV8 w/Grove gear
- I just flew Danny King's 'Beautiful Doll'
- handles on the windscreen frame/roll bar
- top skin alignment...is this correct?
- Cross-Country in an RV-8A
- Inverted Oil, Inverted Fuel and Smoke System
- Extended Range Fuel Tanks on a RV-8
- Wing Mounting
- logistics
- Sad News To Report (crash)
- Z brackets and tank baffle
- Becker Transponder Woes!
- Ram air for -8A
- Vortex Generator question...
- Wings are On! Alignment Question...
- Wing Mounting Lessons Learned
- When to rivet forward deck
- Question re wiring elev trim
- Need Rivet squeezer advice.
- RV-4 verses RV-8 ???
- Flap motor woes
- Flying an RV-8 without the canopy
- S-TEC 55X install kit for sale
- arrgghh!!!
- Gear Leg Fairing Hinge Pin Insertion
- RV Gs
- It's Alive!
- Help, please.
- Avoiding Canopy Cracking (Long Term)
- rudder trim?
- Canopy Stop Source?
- Silver Bullet Tail-wheel steering arm
- Io360 cowling over carburator
- Side-by-side RV-8 - finally!
- MT Prop experience
- Nav Antenna
- WW 200RV and aerobatics
- Accessories, must have?
- Sam James Wheel pants
- The madness has struck another...
- -8 Canopy
- Upper Main Intersection Fairings
- Rookie Countersink Question
- -8 Flap question
- F 849
- RV-8 Performance
- The first 10 Hours...
- Grove Gear?
- Work area
- ASI Calibration
- T-405 Tank Attachment Angle
- VAns' Canopy Lock
- Twenty Hours in the -8!
- Empennage Rivet Head Question
- Jon Johansons Plenum's
- feedback from those with batt in the baggage compartment
- Canopy crack repair
- -8 Fuse Progress
- IO-390 from Aerosport
- Back seat controls in the -8. throttles and brakes
- RV8 Pattern Speeds ???
- Another Milestone- Wings Mounted
- Engine For -8a
- Flap bracket
- Tooling hole near fuel tank inspection plate
- Rudder Balance weight Question.
- plenum kit?
- Fuselage Jig Question
- RV-8 intersection fairings?
- RV-8 Vetterman Exhaust
- Showplane builder in S. Jersey area???
- RV-8 rudder stiffeners
- rudder pedals install ?
- Rolled Leading Edges--advice needed
- How much room in the front seat?
- RV8 nose heavy with IO390?
- Help cutting panel
- 50 Hours!
- RV8 builders in wpb/martin/port saint lucie
- RV 8ers who golf
- Where's the vent?
- another newbie
- Showplanes Fastback
- Newbie from Northern IL
- michigan man checking in
- 200HP vs 180HP
- 100 hr/annual inspection
- Elevator countersinking question
- elevator leading edge
- Rear seat rudder
- aileron attach hardware
- wiring issues
- vans order processing
- First Flight N68AK
- Elevator rod-end jam nut torque
- Rv-8 fastback
- Canopy Covers?
- Manual flaps?
- Emp Trailing Edge radii...
- Empennage fibreglass tips
- max width of gear?
- Assistance needed on wing/emp pre-buy.
- 1/8" aluminium washers
- milspec camlocks
- switching to a -8 from a -7
- Flap Fairing Fit
- fuselage jig
- Bullet Proof???
- engine?
- QB cradle
- Canopy Lock?
- Help with wing wiring, etc
- 8A quickbuild kits in stock!
- Dynon
- RV-8 Pre Buy Inspection
- Show us your panel!
- Tail buffet
- Need Seats
- Where to start on the QB fuse?
- Spins with Carburettor
- Nose Tire Size 8a
- Todd Silver Canopies
- Panel Design Question
- Installing the Canopy - Using glue
- QB fuselage dimensions
- Paul Dye's RV-8 Cockpit Tour
- My RV-8 EFIS
- Which Type of Rudder Pedals?
- Pop out handle
- Balance for first flights
- 85 Hour Maintenance Report
- Tank Access Plate
- Tailwheel Upgrade
- Jig for Empenage and Wing
- canopy stops
- Throttle quadrant cable attach
- n-number
- Anti location on 8A
- part delete credit
- rear throttle plate
- Hinge pin for forward baggage door
- Manual trim cable routing
- Throttle quadrant
- RV8 forward facing sump
- Floor Panels
- Glued fiberglass tips
- F804 carry through section
- 8/8A Yahoo Group Changing Owners
- can't friggen wait!